I'm a music teacher so here is my attempt at a question.
Old single phase 220v motor with magnetic start capacitor switch. When magnet is engaged circuit is open. Magnetic switch has places for 2 wires on magnetic coil and 2 on a set of points (look like points from a lawn mower engine) .
There are 2 wires from capacitor, 4 large wires from motor (2 tied together) and 2 small.
It looks like the on/off switch was for 3 phase, but only 2 large wires hooked to the switch while the other 2 were tied off with a wire nut.
How do I wire this thing to get it to work?
Thanks,
Old single phase 220v motor with magnetic start capacitor switch. When magnet is engaged circuit is open. Magnetic switch has places for 2 wires on magnetic coil and 2 on a set of points (look like points from a lawn mower engine) .
There are 2 wires from capacitor, 4 large wires from motor (2 tied together) and 2 small.
It looks like the on/off switch was for 3 phase, but only 2 large wires hooked to the switch while the other 2 were tied off with a wire nut.
How do I wire this thing to get it to work?
Thanks,
