Beefer3
New Member
Nigel
In the past I have asked you about the IR tutorial. My question was "How do I produce more power from the IR". I have built your tutorial with success. The IR works only when I point in the proximity of the TV. My project is on top of the TV and cannot point directly at the TV itself. The only way to use the IR is to take the project down and set it in fron of the TV.
I have been able to live with this for a while but I would like to "boost" the power some how so that I do not have to keep moving the project from the TV to in front of the TV. I would like to leave it on top of the TV.
So, my question is, if I change the duty cycle of your code, will it help with boosting the signal?
Any suggestions is greatly appreciated.
In the past I have asked you about the IR tutorial. My question was "How do I produce more power from the IR". I have built your tutorial with success. The IR works only when I point in the proximity of the TV. My project is on top of the TV and cannot point directly at the TV itself. The only way to use the IR is to take the project down and set it in fron of the TV.
I have been able to live with this for a while but I would like to "boost" the power some how so that I do not have to keep moving the project from the TV to in front of the TV. I would like to leave it on top of the TV.
So, my question is, if I change the duty cycle of your code, will it help with boosting the signal?
Any suggestions is greatly appreciated.