> Serial EEPROM support:
24LC I2C bus devices:
Bus Speed-
400kHz with Tools -> Fast Programming checked
100kHz with Tools -> Fast Programming unchecked
NOTE: Bus pullups are required for all
programming operations. 400kHz requires
2k Ohm pullups.
Ax Chip Select checkboxes-
These are only enabled for devices that support
address chip selects, and allow programming of
multiple devices on the same bus.
Connections for 24LC devices
---------------------------------------
PICkit 2 Pin 24LC Device Pin (DIP)
(2) Vdd 8 Vcc
(3) GND 4 Vss
(5) PGC 6 SCL (driven as push-pull)
(6) AUX 5 SDA (requires pullup)
7 WP - disabled (GND)
1, 2, 3 Ax pins
Connect to Vdd or GND per
datasheet and to set address
25LC SPI bus devices:
Bus Speed-
~925kHz with Tools -> Fast Programming checked
~245kHz with Tools -> Fast Programming unchecked
Connections for 25LC devices
---------------------------------------
PICkit 2 Pin 25LC Device Pin (DIP)
(1) VPP 1 nCS
(2) Vdd 8 Vcc
(3) GND 4 Vss
(4) PGD 2 SO
(5) PGC 6 SCK
(6) AUX 5 SI
7 nHOLD - disabled (Vdd)
3 nWP - disabled (Vdd)
93LC Microwire bus devices:
Bus Speed-
~925kHz with Tools -> Fast Programming checked
~245kHz with Tools -> Fast Programming unchecked
Connections for 93LC devices
---------------------------------------
PICkit 2 Pin 93LC Device Pin (DIP)
(1) VPP 1 CS
(2) Vdd 8 Vcc
(3) GND 5 Vss
(4) PGD 4 DO
(5) PGC 2 CLK
(6) AUX 3 DI
7 PE - enabled (Vdd)
6 'C' Device ORG
Set to select word size