Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
What I need to do is measure the load on a analog servo and light an LED if the servo should draw excessive power due to a bind in the control linkage from the servo to a control surface.
The INA169 provides an output voltage that is proportional to the current through the resistor. If the TLC2272 was configured as a Schmitt Trigger, it would give you an output when the current increased above the threshold.
However, you may need a low pass filter or delay to prevent triggering to current spikes. Also, motors usually draw a high current on starting.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.