I have found something that might work, but I'll have to make a jumper to supply the "pin 6" with power as well as drill a hole on the board to accept the pin...the other problem is I only need one for testing, but the places I found selling them have min order of around $50....AZ975-1C-12 manufactured by American Zettler may work...Their is a spot to do this and it terminates itself meaning on the reverse side of the board it routes to nothing....I have found many relays that have the pin arrangement I need but they are all reverse and I cannot mount it on the bottom of the board due to space constraints....I can use an external 12V general auto relay but I was trying to find a "cleaner" substitute since I want to start rebuilding these modules to earn some extra cash...The relays installed on the boards are notorious for failing, 90% of these modules fail because of this, and the soldered joints fail as well due to minor temp changes producing cold joints....Very bad design and poor quality control....