Hi rs14,
here is the entire device for your switch. I guess I'll have use for it as well since it is really small.
I connected the solder pads at the front end to pins. Connecting those pins to circuit ground might be useful when switching high frequencies, since the switch seems to be completely metal encapsuled.
When dropping the switch onto a schematic activate the pins layer. You'll see two unnamed pins seeming to go nowhere. They are in fact connected to those mentioned solder pads.
You will see the package outline as posted if layer51 is activated. After deactivating it there won't be any annoying contour lines across the SMD pads. (Layer51 is never used in board houses.)
The test board connects OK.
I like Tennessee people. They used to fire their rifles at our planes after too many of them had been caught brewing moonshine in the woods.
We made nice infrared "movies" of the distilleries.
Regards
Boncuk