rancid rock
New Member
hey,
i need a circuit similar or the same as the following:
needs two pressure pads preferably (one on each side of the door)
And a door that opens when the pressure pad is pushed down, then stays open for a timed 10 seconds and then finally closes again unless the pressure pad is pushed which would reset the timer
if u know how to, or have a circuit like this or similar coud u plz post here, because i can always make modifications to both the project or circuit.
I will be using a microcontroler PICAXE 18.
Also any advice or comments are welcome
thankyou,
i need a circuit similar or the same as the following:
needs two pressure pads preferably (one on each side of the door)
And a door that opens when the pressure pad is pushed down, then stays open for a timed 10 seconds and then finally closes again unless the pressure pad is pushed which would reset the timer
if u know how to, or have a circuit like this or similar coud u plz post here, because i can always make modifications to both the project or circuit.
I will be using a microcontroler PICAXE 18.
Also any advice or comments are welcome
thankyou,