Billy22Bob
New Member
I bought this faucet which is designed to run on 6V made up of 4 x 1.5V batteries.
**broken link removed**
I estimated the unit wouldnt drag any more than 100mA and checked with the supplier that this was the case and that a 240-6V DC power adapter would be suitable to replace the battery pack. Confirmed.
Installed the unit and its fine except for 1 thing.
The colour changes with temperature limits - blue for cold, green for warm red for hot and red flashing for very hot.
The blue, green and red are fine - however the red flashing is "stuttering" for want of a better description. It flashes intermittently at high rates as opposed to a steady 300ms flash when under battery power.
It only does it on the PS and not the 6V battery pack.
I suspect I bought and am using a switched mode PS (very light). Would this be causing the stuttering or would I be better to upgrade to a 200mA unit?....or both.
**broken link removed**
I estimated the unit wouldnt drag any more than 100mA and checked with the supplier that this was the case and that a 240-6V DC power adapter would be suitable to replace the battery pack. Confirmed.
Installed the unit and its fine except for 1 thing.
The colour changes with temperature limits - blue for cold, green for warm red for hot and red flashing for very hot.
The blue, green and red are fine - however the red flashing is "stuttering" for want of a better description. It flashes intermittently at high rates as opposed to a steady 300ms flash when under battery power.
It only does it on the PS and not the 6V battery pack.
I suspect I bought and am using a switched mode PS (very light). Would this be causing the stuttering or would I be better to upgrade to a 200mA unit?....or both.