Hi Everyone,
I am new to the forum, so I apologize in advance if I've made any mistakes in posting this question here
I am working on an electronics project for Uni and am trying to design a basic circuit that can power a DC motor in two directions. I am planning to use an H-bridge design using MOSFETs as electronic switches. I've attached a rough diagram of my proposed circuit and will be using the following components below:
MTP3055E MOSFETs
1N4004 Diodes
YG2732 DC Motor (rated 12V, 4-18Vmax)
Obviously the gate voltage of 5V would only ever be applied to Q1 and Q4 OR Q2 and Q3 to provide the opposite rotations in the motor.
Do you guys think this design will work or am I missing some crucial bits here?
Any feedback would be greatly appreciated!
**broken link removed**
I am new to the forum, so I apologize in advance if I've made any mistakes in posting this question here
I am working on an electronics project for Uni and am trying to design a basic circuit that can power a DC motor in two directions. I am planning to use an H-bridge design using MOSFETs as electronic switches. I've attached a rough diagram of my proposed circuit and will be using the following components below:
MTP3055E MOSFETs
1N4004 Diodes
YG2732 DC Motor (rated 12V, 4-18Vmax)
Obviously the gate voltage of 5V would only ever be applied to Q1 and Q4 OR Q2 and Q3 to provide the opposite rotations in the motor.
Do you guys think this design will work or am I missing some crucial bits here?
Any feedback would be greatly appreciated!
**broken link removed**