hello all,
iam looking for a linear type of voltage multiplier circuit.
my requirement is in Milli volts.imean when i fed it 250mv (DC) the output shld get multiplied by 4 times ie 1000mv (DC) and for 500mv input 2000mv shld be the output.the whole circuit shld be very much linear.
is it possible with some chip.i really need help in this issue.
thanks and regards
You really need to give more details of EXACTLY what you're trying to do, an opamp AMPLIFIER 'may' do what you want, but your term 'VOLTAGE MULTIPLIER' is something completely different, unless you're using the term incorrectly?.
Do you have any voltages available other than the voltage you want to multiply? If not, the task is impossible.
If you have other voltages, then your task is to find an "amplifier". For an amplifier you'll need to specify gain, frequency response, impedance, and/or current output requirements.
It might be easier to tell us what it is supposed to accomplish. What is the input device, and what is the amplifier supposed to drive?
DC voltage multiplier?
Is switching converter or just amplifier?
Switching converter will change voltage sources (batteries, etc.) to different voltage. It operates with input 2V or above. (require power to operate).
For amplifier, read on @mneary.
For the OP, typically one says they need a voltage gain of 4 when doing what it seems like what you want to do. When one says voltage multiplier that usually means multiplying to voltages that can vary (i.e. signals) like z(t) = x(t)*y(t) instead of z(t) = 4*x(t)
Multiplying is a more general case and is more compilcated.
There are IC's that can do the multiplying if you want to use them but a simple opamp with a constant closed-loop gain is much more readily available and easier to cook up.
But this is all small signal design. You havn't revealed what kind of load you want to drive or other details which, may eliminate using an opamp altogether.