Lenze Drive

hello friend
i use the Lenze drive to controlling stepper motor. my deive is runnig complate but each time i gate error about OC2 .
i also read the full manual of lenze drive but there is not enough solution so any one can help to how i remove the error.

regard,
nick

"OC" might stand for "Open Collector" or "Output Control" or many other things. Try going to **broken link removed** and ask them directly. Be sure to include the controller model number.

You can find all the current Lenze Drives at the following page.

http://www.ctiautomation.net/Lenze-Frequency-Inverters.htm

Hi...
I have doubt regarding Lenze 8200 vector drive with LECOM B communication module.
PLC Send/Receive telegrams to above drive through LECOM B. How to findout parameter numbers and func from below telegrams,
04 31 31 32 30 05 02 32 30 30 30 33 30 03 02
04 31 31 32 31 05 02 32 31 30 31 30 30 03 01
04 31 31 32 32 05 02 32 32 30 33 31 38 03 09
04 31 31 32 33 05 02 32 33 30 31 38 36 03 0D
04 31 31 32 34 05 02 32 34 30 31 33 35 03 02
04 31 31 32 35 05 02 32 35 30 30 30 30 03 04
04 31 31 32 36 05 02 32 36 30 30 32 35 03 00
04 31 31 32 37 05 02 32 37 30 30 34 37 03 05
04 31 31 33 33 05 02 33 33 31 31 35 32 03 04
04 31 31 33 34 05 02 33 34 30 38 33 37 03 08
04 31 31 32 38 05 02 32 38 39 30 30 30 03 00

04 31 31 02 32 39 30 34 32 30 03 0E 06
04 31 31 02 33 30 30 38 35 32 03 0F 06
04 31 31 02 33 31 31 34 37 36 03 05 06
04 31 31 02 33 32 30 30 30 30 03 02 06

thanks