Im building a LCD to parallel hookup for someone over at pimprig.com, I hooked it up, and all I get is the initilazation screen. It stays like that even if I input data from the parallel port.
My Question is, Could it have been damaged enough not to operate (but still turn on to the initalization screen) by ESD?
The data sheet says Be Sure you are grounded when Handling LCM. I practically sit in a metal chair at all times, and I never touched it when I was working on it.
If you hook up a pin really wrong, like mixing up V+ and V-, sure you can damage it. This would unfortunately be difficult to diagnose without a second LCD when hardware and software problems are likely.
If you have nothing at all on the screen, you probably have not generated a proper contrast voltage. Seems half the experimenters who get stuck have this problem.
Not to menthon an too high contrast voltage will make evry segment go black.You get black blocks.This looks a lot like the LCD has not ben inichalised.Pluging the contrast directly to the 5V rail will cause this,
Well Guys, No need to worry now, since I made a big mistake. When I was unsoldering the wires, I accidentaly got some solder on the nearby resistors. Not thinking, I got a pair of pliers and pulled the solder off. But in doing so, I pulled the Pad off the resistor. Opps
It is repairable, if I get another SMD resistor. But I still wont know if it will still work