ranjot singh
New Member
i have connected the pins 1 n 15, i.e. current sensing to ground.
i have given 8 volts as vsource and 5v as vcc.
now when i conneccted the motor at output then the ic got too hot n the valude of vsource reduced to 5 volts and motor didn't run. Now i think the ic got burnt out but can't understand why. so plz help
i have given 8 volts as vsource and 5v as vcc.
now when i conneccted the motor at output then the ic got too hot n the valude of vsource reduced to 5 volts and motor didn't run. Now i think the ic got burnt out but can't understand why. so plz help