I decided to take some measures for you to give some advice:
Marked | Measured
C33 10 uf 16v O.L.
C22 47 uf 16v 50.1 uf
C26 10 uf 16v 10.3 uf
C2 470 uf 10v O.L.
C21 100 uf 25v 101 uf
C12 3.3 uf 50v 3.3 uf
C11 3.3 uf 50v 3.4 uf
C1 470 uf 25v O.L.
C6 10 uf 50v 10.2 uf
C5 47 uf 16v 54.1 uf
C9 100 uf 25v O.L.
C14 10 uf 16v 11.3 uf
C7 2.2 uf 50v 2.5 uf
C25 10 uf 50v 10.4 uf
View attachment 74228
L1 ???? 0.3
L5 ???? 0
(I measure L5 with no polarity like so:
1 connects with 2 I get 0 (connectivity).
And 3 connects with 5 also get 0.
Another combination does get connectivity)
View attachment 74227
D4 ???? 0.593
D8 ???? 0.593
D9 ???? 0.587
Heres the images (with more quality) with capacitors and coil indentified:
View attachment 74225
View attachment 74226
In this measures I did not desolder components out of PCB i decided to take them out only when they cause some doubt...
(I was kind surprised beacause i did get the values too close of what they mark without take them out of PCB)
And thats my problem because I dont know where is the problem. How can I test if its a moisture problem? Connectivity test is enough?
Do you want me to make another test and can you give some more advice?