K112 Pocket Sample Problems

Status
Not open for further replies.
S

slakkie

New Member
I am trying to get the voltage of this device and it doesn't seem to respond. I have all the latest software.

I have made a cable for it and pluggled the positive to the battery positive and the negative to the battery negative. Nothing gets logged at all.

**broken link removed**

I have tried everything already including turning the potentiometer while checking the readings. It is simply dead and I am stuck! I am running windows XP.

 

Is this a kit that you have built yourself...? If so I would check the quality of your construction as a first step. If that looks OK, then you should be checking the software that runs the device to make sure it's installed correctly, etc.

Unfortunately it's highly unlikely that you will get a response along the lines "Your problem is X and the answer is Y" because there are so many different faults that could be causing the issue.
 
Status
Not open for further replies.

Similar threads

R
  • Question
Any potential problems with my diy home battery?
Replies
6
Views
3K
Diver300
D
F
  • Question
Offline SMPS has no impedance from mains input ......problems?
Replies
0
Views
2K
Flyback
F
P
Problems with the circuit
Replies
6
Views
2K
Piscis
P
C
Digital Counters Counts Sample External Frequency Wrongly
Replies
19
Views
3K
Cable
C
V
Micro-Current Measurement Circuit Problems
Replies
7
Views
2K
Visitor
V
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…