junebug and swordfish problem

ghostman11

Well-Known Member

• Jan 2, 2010

• #1

i have tried to program the junebug using swordfish and i keep getting the following error please reset the target microcontroller in order to access the bootloader process! any ideas what might be wrong?? the bug was working when i last tried it i put it away for a few days over xmas and now i get this error?

 

3v0

Coop Build Coordinator

Forum Supporter

• Jan 2, 2010

• #2

If you are in MPLAB or any IDE you need to select the hardware tool used for programming or debugging. For the Junebug select PicKit2.

It seems you are attempting to talk to a bootloader that you do not need with a junebug.

 

ghostman11

Well-Known Member

• Jan 2, 2010

• #3

thats odd all i have on is the swordfish. mplab isnt open???? i have no idea why its started doing this

 

P

Pommie

Well-Known Member

Most Helpful Member

• Jan 2, 2010

• #4

It sounds like you are using a bootloader. Can you try starting a new project and just blink an led or something.

Mike.

 

P

Pommie

Well-Known Member

Most Helpful Member

• Jan 2, 2010

• #5

Found the problem,

Under View->Compile and Program option, select the programmer tab and select Junebug.

Mike.

 

ghostman11

Well-Known Member

• Jan 2, 2010

• #6

well done pomie! strange thing is somehow the june bug option i set up has gone!! so have set up again and now works once more thanks guys i been tearing my hair out