been hacking at some code the last few days using the ICSP socket/ribbon cable to test daughter board.
this morning all I get is device not found or memory address 0x0000000 not blank.
flipped the dip switches to on to see if I can blank check etc the 18F1320 on the Junebug.
Works but now ledA6 stays on sometimes for no reason.
do I need to re program the tutor pic or?
this happened all of a sudden when I started this morning.
Just the sniffles?
After I programed with the daughter board connected to a battery it can now run using the USB power
WHY??
All I know is now it works???