inverter driver

Status
Not open for further replies.

muhammad59

New Member
1-is this good driver for inverter ??
2-why use diode and capacitor ??
3-how determine or know correct resistor sizes ??
 
The 100R's are just to turn the transistors off.
The circuit will not work properly.
The 2N3055's will not turn ON fully.
It's just a very bad design.
 
Last edited:
Status
Not open for further replies.

Similar threads

A
TL072 and Non-inverter small signal amplifying
2 3
Replies
43
Views
6K
arvinfx
A
A
  • Solved
Buck/Boost Converter
Replies
7
Views
597
Tony Stewart
V
  • Question
Analog or gate
Replies
3
Views
901
Tony Stewart
I
  • Question
Can I use BP2857 constant current LED driver IC with a PWM-controlled MOSFET for dimming and turning the lights on or off with an ESP8266/Arduino?
Replies
5
Views
2K
Tony Stewart
E
  • Question
H-bridge driver board with input for direction
Replies
4
Views
2K
Erhy
E
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…