hello
sorry for my English (I am French, I hope you understand)
I try to interrupt on RB0 Flowcode with, but I can not
I board read all the manuals, all manuals, impossible to understand
simulation it works, but RB0 (interruption) does not work
There's one here if specialist Flowcode I am willing to post my program
I board tried to have the following operation
RB1 RB0 input or on -> turns on the LED associated with it
(RB0 -> ra0) / (RB1 -> ra1) ---> Correct functioning
RB4 -> Manual reset
I want to reset it after few seconds after switching on a led (or RA0 or RA1) .. .. automatically without removing the manual reset (RB4)
(led rao or led ra1 --> on.....after 10 sec reset...rb0)
thanks
sorry for my English (I am French, I hope you understand)
I try to interrupt on RB0 Flowcode with, but I can not
I board read all the manuals, all manuals, impossible to understand
simulation it works, but RB0 (interruption) does not work
There's one here if specialist Flowcode I am willing to post my program
I board tried to have the following operation
RB1 RB0 input or on -> turns on the LED associated with it
(RB0 -> ra0) / (RB1 -> ra1) ---> Correct functioning
RB4 -> Manual reset
I want to reset it after few seconds after switching on a led (or RA0 or RA1) .. .. automatically without removing the manual reset (RB4)
(led rao or led ra1 --> on.....after 10 sec reset...rb0)
thanks
Last edited: