blueroomelectronics
Well-Known Member
I've posted the Inchworm+ assembly manual on my site, schematics, BOM, etc.
Some of you already know about the new Inchworm+ but I have a surprise for you.
I've been working on the Unicorn, a USB upgrade for the Inchworm+
Unicorn uses the 18F4550 and can power the Inchworm+ and it's target up to 400ma.
And better yet I've designed Unicorn to be a USB experimenter too.
Or
You can plug in a 2x16 LCD and use it as a USB experimenter
Or
Buy two and sandwich the Inchworm+ between them as a USB-LAB
Note: you can go back and forth between experimenter & ICD2 upgrade. Just depends on how you connect it.
PS you use the Inchworm in serial mode to program it initally...
Some of you already know about the new Inchworm+ but I have a surprise for you.
I've been working on the Unicorn, a USB upgrade for the Inchworm+
Unicorn uses the 18F4550 and can power the Inchworm+ and it's target up to 400ma.
And better yet I've designed Unicorn to be a USB experimenter too.
- ICD2 for Inchworm (any version)
- 2x16 LCD with backlight control
- 4 push buttons under the LCD
- USB
- RS485
Or
You can plug in a 2x16 LCD and use it as a USB experimenter
Or
Buy two and sandwich the Inchworm+ between them as a USB-LAB
Note: you can go back and forth between experimenter & ICD2 upgrade. Just depends on how you connect it.
PS you use the Inchworm in serial mode to program it initally...
Last edited: