I'm having a few problems
Inchworm is built and I've connected it up and setup mplab - disabled fifo, using a 1:1 serial cable. When connecting in mplab I get the following:
Connecting to MPLAB ICD 2
...Connected
ICDWarn0054: MPLAB IDE has lost communications with the MPLAB ICD 2. Would you like to attempt to reconnect?
Connecting to MPLAB ICD 2
...Connected
ICD0286: Unable to communicate with ICD
ICD0082: Failed MPLAB ICD 2 operation
MPLAB ICD 2 Ready
If I try and run the self test in status the same error occurs as above. I've read a few posts with similiar problems - already checked the cable. Also viewing the power in mplab shows 0.00
If I try and do a download OS I get:
Downloading Operating System
ICD0152: Failed to read all of requested bytes (0x0 of 0x8)
...Download Operating System Failed
ICD0152: Failed to read all of requested bytes (0x0 of 0x2)
ICD0082: Failed MPLAB ICD 2 operation
ICD0082: Failed MPLAB ICD 2 operation
ICD0082: Failed MPLAB ICD 2 operation
ICD0082: Failed MPLAB ICD 2 operation
MPLAB ICD 2 Ready
I've not yet connected any pics up to the inchworm.
Update: I've also checked the 5V and TP VPP=13.36V