L lgsmallbird New Member Mar 2, 2011 #1 Hi,people. when using LM3S811 Eval board to connect LM6059BCW(LCD),I can't find the slave address of LM6059BCW using I2C mode. function:I2CMasterSlaveAddrSet() need the address of the LM6059BCW. Everybody who can tell me the slave address of the LM6059BCW, very thanks!
Hi,people. when using LM3S811 Eval board to connect LM6059BCW(LCD),I can't find the slave address of LM6059BCW using I2C mode. function:I2CMasterSlaveAddrSet() need the address of the LM6059BCW. Everybody who can tell me the slave address of the LM6059BCW, very thanks!
blueroomelectronics Well-Known Member Mar 2, 2011 #2 It's not an I2C device. It's parallel like most 128x64 graphic displays. https://www.topwaydisplay.com/Pub/Manual/LM6059BCW-Manual-Rev0.3.pdf
It's not an I2C device. It's parallel like most 128x64 graphic displays. https://www.topwaydisplay.com/Pub/Manual/LM6059BCW-Manual-Rev0.3.pdf
L lgsmallbird New Member Mar 2, 2011 #3 Oh,I see. thanks very much. perhaps i can use GPIO to do that.