Here is my schematic. sorry about the rough drawn. i figured it would be faster. I am having the output of the j/k flip flop to flip power off to most components when the counter reaches 5. but the counter continues counting and nothing turns off.
i have hooked up an alarm to trigger the 'J' value to high when the alarm goes off, thus i figured that when the k value is triggered by the counter turning '5', it would toggle the Q state, the components (except for the timer and the jk), then the alarm would run out, and it would be able to start all over again on the next alarm signal.
i noticed that the jk doesn't change until it is clocked, do you think this has anything to do with the positive edge components?
any help would be great. thanks!