I was thinking I could use this but I will hve to go with 10VA or higher, yes or no? Or is this saying 6VA for only one side of the secondary so using both 12 would be 12VA?
If it is the total of both as the notes above then I should be able to use it.
This is the board with the two of them "PT 1-00/15-2, prm 110v 60HZ 10VA, sek 15v 0.33A 15v 0.33A" there are two of them
I'd say go for it. The primary is slightly different ~5%. The secondary currents are larger. The seconday currents matter. What you don't know is the efficiency of the xformer. The secondary currents matter most.
This is what I ordered it's more like the other but mounts diff. The way the VA is being rated on the FP30-200 I don't get it cause that transformer is way to small....