samuel.sam77
Member
hi i am using pic 16f690 enhanced pwm there is auto shut mode ..CCP_SHUTDOWN_ON_INT0.. am using this command
how to give low signal to this pin (17 pin ) INT..the below ckt is i connected but output not getting ..
if i remove the transistor it is working (PWM)
the base always pulled down to gnd
also base signal is zero
any one help me
how to give low signal to this pin (17 pin ) INT..the below ckt is i connected but output not getting ..
if i remove the transistor it is working (PWM)
the base always pulled down to gnd
also base signal is zero
any one help me
Last edited: