Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

How to change X-axis in plots of Advanced Design System?

Status
Not open for further replies.

genxium

New Member
I just finished a small design with Advanced Design System 2008, under AC Simulation I set a Parameter Sweeper to change a D.C. voltage value, but when I run the simulation and plot, the X-axis is frequency, how can I change it to the D.C. voltage I swept?

My design is the attached figure.
 

alec_t

Well-Known Member
Most Helpful Member
I'm not familiar with ADS, but if it's similar to LTSpice then I think an AC Sim will always have frequency on the X-axis. Try a different type of simulation (DC?).
 
Status
Not open for further replies.

Latest threads

Top