I would like to use the handy LM386 audio amp. How to wire the ic output to piezo?
The piezo speaker data sheet as follows;
Impedance: 300 ohm
Input voltage : 3vrms
Max input voltage: 20 p-p
Min output: 75 dba
Freq. range: 300-20,000hz
Device takes less than 20 V pp; so use an amplifier with about 15 volts rail supply; I think the LM386 IC can do it, connect as if it was any plain speaker per IC data sheet.
What sounds will the horrible-sounding piezo transducer play?
Its loudness is very low and since it resonates at 1800Hz then it will not produce low frequencies.
It might produce faint childrens' voices pretty well.