homeing tracker

Status
Not open for further replies.

Dr_Doggy

Well-Known Member
I'v recently been looking at a light seeking robot that runs off of a op amp and two photoresistors , would it be possible to make a tracker for a rf homeing beacon using the same principals of the opamp by replaceing the photosensors with 2 LC antenna tuners?
 

Not unless you use very short wavelengths, i.e. 2.4GHz or higher. Then you will need an electronically switched antenna, a complete AM receiver, followed by a synchronous detector, a low pass filter, and finally a servo amplifier.
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…