X xbecomingx New Member Oct 6, 2009 #1 So id like to build my 1st pcb. however im not sure how to go about it. what i have to start with is (2x) 3.7v 900mah li-ion batteries. i need an output voltage of atleast 12volts to run a small project moter. with a pot to control voltage/speed is this possable
So id like to build my 1st pcb. however im not sure how to go about it. what i have to start with is (2x) 3.7v 900mah li-ion batteries. i need an output voltage of atleast 12volts to run a small project moter. with a pot to control voltage/speed is this possable
X xbecomingx New Member Oct 6, 2009 #3 because the motor isent actually a rotating motor its a coil setup.