help w/ propeller clock

am, good day everyone! I'm a newbie here. . .

I wanted to ask about the project I found over the net. I think some of you may have encounter this site **broken link removed**

we are trying to build this propeller clock, but then in the diagram there is this "berg connector" which we are not familiar with . . .

Am, I wanted to ask if it is ok if we do not use berg connetor and instead use directly a connecting wire (jumper)...

thanks for dropping by, hope someone could help us here. . .

The answer to your question is on the page you posted a link for... It's just a standard PC header style connector .025 square pins on .1 inch centers. You can replace it with any style header of PCB connector you wish.

thank you!

thanks!! c",)