Help identifying the component?

I have a quad charger that is split into 4 separate sections and one section doesn’t charge anymore. I have located what I think is a thermistor and on the shrink tube it says 125degrees C. I cut the shrink tube and it s a 33ohms resistor. I am including pictures of it. Please help me identify it. So, it should test at 0.4 ohms and probably go up in resistance with the rise in temp, instead it's OC. On the board it clearly says R for resistor. But it has to be a special one.
Thanks in advance

Nothing special about it - it is a 0.33 ohm fusible resistor.

If it is reading 0.4 ohms on your meter then it is OK.

There are 4 of them on the board and the good ones read that. The one I need is reads open.
I thought the orange orange silver gold and green was 33ohms but I guess the green is nothing important so without that, it does read 0.33ohms.
Would this one do?

As it's a fusible resistor, it should be replaced with a fusible resistor - it's a protection device.

eg.

What are the dimensions of the body, length and diameter?

ps. The third band in the coding is silver, which is a "-2".

I don't have it with me right now but it is roughly 1/2 inch long by .20 give or take type through hole and it is in some sort of shrink tube that says 125 degrees celsius

125 degrees celsius is just the temperature rating of the heatshrink tube, has nothing to do with the resistor.