ladybreaker
New Member
Attached is schematic of single push on/off involving a 555 ic to act as a switch for a set of LED day running light. I think the schematic is complete because it was taken from a pcb layout of the actual switch.
As it stand , the light are not coming ON at ignition ON , I need to press the SW for this, so I bridged the SW and the LED are coming on on power up of the circuit.
But for some reason the DRL are tuning off after 30 to 40 min.
Is it because I bridged the SW , is there a better solution to modify the circuit to switch the DRL on at power up ?
Thanks
As it stand , the light are not coming ON at ignition ON , I need to press the SW for this, so I bridged the SW and the LED are coming on on power up of the circuit.
But for some reason the DRL are tuning off after 30 to 40 min.
Is it because I bridged the SW , is there a better solution to modify the circuit to switch the DRL on at power up ?
Thanks