finally I have made my first pcb at home

Status
Not open for further replies.
N

nightcatz

New Member
hi,
Finally have made my own pcb at home thanks to nice link by gayan,and spl thanks to gary for this design,from now on I will be busy trying to make my own pcb design ....it is really helpful and the process of etching using ferric chloride with it heated really speeds up the process,my 2"x2" board is done in 30 min............i forgot to mention the process was speeded up after i added a little hcl(diluted)
 

Attachments

  • Picture 003.jpg
    10.5 KB · Views: 645
  • Picture 001.jpg
    9.1 KB · Views: 176
  • Picture 014.jpg
    8.6 KB · Views: 224
Last edited:
Wow it looks good.It looks like an AMP circuit for me.

From which software did you make the drawing? or by hand?

Next time you can reduce the Track Width in your PCB Designs.
 
its clay coted paper.
usually u'll find it in costly magazines.when u touch it ,it felt smooth and shiny.
and don't go for very thick paper.will be little hard while socking.
 
i have been useing magizine paper also but its the kind that student is talking about (although i didn't know about the clay). the only problem is i only had one magazine and it wasn't realy a magazine,another words i can't just go buy one.you know of any magazines made with the whole book like this. it is well worth any extra money. i gues like specail editions and stuff
 
Try this post:
Electronic Circuits and Projects Forum
Circuit Simulation & PCB Design
new method to manufacture pcb at home
 
Sorry. I'll try to find only recent posts.
Click to expand...
Please don't. It's bad practice. Members get annoyed at duplicate posts. You've already got a post in the relevant forum (Circuit simulation & pcb design). If it proves popular the Mods might make it a 'sticky'.
 
Last edited:
Status
Not open for further replies.

Similar threads

R
  • Question
Any potential problems with my diy home battery?
Replies
6
Views
3K
Diver300
D
T
Could use checking of my schematic for Teensy Audio Shield pcb
Replies
17
Views
3K
TonyAme
T
S
  • Question
My first schematic of a 2-channel relay board
2
Replies
35
Views
5K
eTech
E
B
  • Question
Schematic PCB review - Capacitive Touch Sensor AT42QT1012
Replies
4
Views
2K
Tony Stewart
E
  • Question
Building a Crystal Radio first time
Replies
16
Views
3K
edteach2
E
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…