I am new to programming a pic and i need some desperate help with programming my pic. I have a PIC16F628-041/p chip and i have tried programming it with my two different home made programmers one is a serial JDM and the other is a Parallel P16PRO. I have also use the many different common software out there and they all keep giving me the same error. Verify Failed at 0x0000. I am trying to make a mood light for my design project at my community college (SCC). I am cutting it close to getting my project done and this is the last thing that i got to do. I have read all different forms about this pic but i cant figure out why i cant get mine to program. I am going to upload the hex files and the other information that i got for this project. Also i got my parallel port programmer from winpicprog.co.uk and my serial port programmer from talkingelectronics.com. then to multi chip programmer
WinPicProg has manual toggle buttons so you can set the output pins high or low - Vpp should be near 13V, and the data and clock lines should be near 5V.