i wrote a code that takes a byte from a dip switch and write it on an eeprom then read the byte from the eeprom and display it to leds
the problem is that when i display the first byte and then i want to display the second byte i can't unless i do a reset
what i suspected it would be wrong is the fact that i sent a NOACK from pic to eeprom after the read this is where the block happens
can somebody tell me if i shouldn't use the noack when i'm reading only one byte then doing stop
the problem is that when i display the first byte and then i want to display the second byte i can't unless i do a reset
what i suspected it would be wrong is the fact that i sent a NOACK from pic to eeprom after the read this is where the block happens
can somebody tell me if i shouldn't use the noack when i'm reading only one byte then doing stop