Dorji RF Receiver Problem

Hil all, i have a problem with Dorji Rf Receiver. My transmitter sends data in 53 second period but i cant receive them. I am taking rubbish signals. When i connect data pin to scope. I am seeing a screen like that



In addition. I cant see any data at logic analyzer.

What i should do ?

It is my RF receiver module



Thanks for help

hi Taban,

It may not be the root cause of your RX noise problem, but an un-tinned piece of copper wire wrapped around the RX antenna pin is not a good idea.

E

Thanks for reply but problem isnt that .

Taban said:

Hil all, i have a problem with Dorji Rf Receiver.

Click to expand...

Has this ever worked correctly, or are you trying to make it work for the first time?

Taban said:

My transmitter sends data in 53 second period but i cant receive them.

Click to expand...

How do you know that the RF signal out of the transmitter is correct?

Taban said:

I am taking rubbish signals. When i connect data pin to scope. I am seeing a screen like that
View attachment 74659

Click to expand...

Your scope shows a 500mV signal, are you using a x10 divider probe?
Otherwise something is very wrong.
What is your data rate into the transmitter? If it is too fast, it will not transmit correctly.

Taban said:

It is my RF receiver module

View attachment 74660

Click to expand...

Rather than a picture of a standard module, a datasheet would have been better and some schematic of your connections to the transmitter and receiver modules.

By the way, what is the gash piece of wire wrapped around one of the module pins?

JimB

JimB said:

Has this ever worked correctly, or are you trying to make it work for the first time?

Click to expand...

I am trying first.

How do you know that the RF signal out of the transmitter is correct?

Click to expand...

I connected transmitter to logic analyzer and i saw data, it sends data well.

Your scope shows a 500mV signal, are you using a x10 divider probe?

Click to expand...

Yes i use

What is your data rate into the transmitter? If it is too fast, it will not transmit correctly.

Click to expand...

Bit rate is 1024 Hz.

Rather than a picture of a standard module, a datasheet would have been better and some schematic of your connections to the transmitter and receiver modules.

Click to expand...

Okey, It is datasheet of receiver;
https://www.wiltronics.com.au/datasheets/DORJI/RF-DRA886RX.pdf

By the way, what is the gash piece of wire wrapped around one of the module pins?

Click to expand...

It is 17,4 cm antenna.

Rather than a picture of a standard module, a datasheet would have been better and some schematic of your connections to the transmitter and receiver modules.

Click to expand...

Okey, It is datasheet of receiver;
https://www.electro-tech-online.com/custompdfs/2013/07/RF-DRA886RX-1.pdf

Click to expand...

no, that's not what JimB meant, you just did the same thing

show us YOUR construction so we can look for wiring errors etc, your receiver board isn't going to work without power connections etc
lets see it all

Dave

It is my construction. Yellow cables go to ground, green one goes to 5V, and orange cable is data cable. I connect it to PIC or Scope . All of them directly connected. There is no extra thing. That capacitor(47 uF), i soldered it as external to prevent AGC by looking IC's(SYN470R) datasheet which inside my receiver module.

in your receiver picture, you don't connect to the data output pin.
also, you didn't use any antenna.
here is its pin definition:


this receiver is produced by us. we totally know its situation.