Mosaic
Well-Known Member
Hi guyz...
Going to be getting a Klik N Kut Die cutter that can do engraving etc.
based on this video:
https://www.youtube.com/watch?v=7cAzV9rCay0&NR=1
I figure it can engrave away resist coatings. So I plan to spray on some lacquer on the prepped copper and then have the die cutter expose copper to be etched. Etch and that's it. Might be more precise & repeatable than the iron on approach, not to mention capable of processing over a square foot of board at a time....which is kinda tough from the iron on perspective.
Clearly that diecutter also has a million other uses....making faceplates, lettering for project housings, Solder mask stencils, gaskets, kids craft....etc.
Sounds doable?
Going to be getting a Klik N Kut Die cutter that can do engraving etc.
based on this video:
https://www.youtube.com/watch?v=7cAzV9rCay0&NR=1
I figure it can engrave away resist coatings. So I plan to spray on some lacquer on the prepped copper and then have the die cutter expose copper to be etched. Etch and that's it. Might be more precise & repeatable than the iron on approach, not to mention capable of processing over a square foot of board at a time....which is kinda tough from the iron on perspective.
Clearly that diecutter also has a million other uses....making faceplates, lettering for project housings, Solder mask stencils, gaskets, kids craft....etc.
Sounds doable?