digital clock

Status
Not open for further replies.

dumbguy1

New Member
I've written an assembly language program to make a digital clock using an MC68HC12 microcontroller. The one second delay works perfectly, but the program hangs up after three counts. I've gone through the code multiple times and have been unable to determine what the error could be.
 
 

dumbguy1 said:
figured it out no thanks to you dumbasses

Hmm, where should I start with this .... perhaps that you posted about as little information as possible so that we could help you with your problem ... or was it that you waited just a hair over 12 hours for all the engineers to rush to your aid .... or was it the poor attempt to insult those of us who try to provide friendly assistance ... or was it your overt attempt to demonstrate your technical acuity and general enlightenment in a sea of callowness and fatuity.

You can read about me Here ... then in the future, perhaps you can activate a few of your neurons prior to making such a bold generalization about our technical talent.
 
Out of interest surendra, did dumbguy1 ever e-mail you any info, or is he just as obtuse as he sounds.

Personally. I've appreciated all the help found here so this post amused me no end. :lol:
 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…