G guosen New Member Feb 3, 2004 #1 hey ,there. I was wondering if anyone could give me guidance or tips on how to design a system which will measure the contact switiching time of electromechanical relays. I would be very grateful if someone could reply to this topic and help me out. Thanx!!
hey ,there. I was wondering if anyone could give me guidance or tips on how to design a system which will measure the contact switiching time of electromechanical relays. I would be very grateful if someone could reply to this topic and help me out. Thanx!!
R Russlk New Member Feb 3, 2004 #2 You need an interval counter and gates to start and stop the count.
Nigel Goodwin Super Moderator Most Helpful Member Feb 3, 2004 #3 This has already been asked in a previous thread, have a look at https://www.electro-tech-online.com/threads/pic16f630-calibration-code.6078/. I'll ask the same question again though, why do you need to do it? - perhaps a relay isn't what you should be using.
This has already been asked in a previous thread, have a look at https://www.electro-tech-online.com/threads/pic16f630-calibration-code.6078/. I'll ask the same question again though, why do you need to do it? - perhaps a relay isn't what you should be using.