Hey all, I have a question.
I have a pressure sensor that outputs anywhere from 0v to 5v. I need to take that voltage (within that range) and convert it to the pulse width needed to drive a servo. I think its between .8msec and .22msec. I don't know much about servos or regulation like this. Nor do i know how to create a cicuit for this.
I realize that there will be some that do not understand why I am doing this, but that is another topic. I would like to find a schematic and or circuit of how to convert dc into pulses used to control a servo.
Any ideas would be greatly appreciated
thnx
I have a pressure sensor that outputs anywhere from 0v to 5v. I need to take that voltage (within that range) and convert it to the pulse width needed to drive a servo. I think its between .8msec and .22msec. I don't know much about servos or regulation like this. Nor do i know how to create a cicuit for this.
I realize that there will be some that do not understand why I am doing this, but that is another topic. I would like to find a schematic and or circuit of how to convert dc into pulses used to control a servo.
Any ideas would be greatly appreciated
thnx