Pax Writer
New Member
Hi experts
I need to do some stress-testing of a DC-motor control circuit, but without the motor - Problem is, I'm not sure how to make this the most clever (and cheap) way.
I need to run 30-40A through my circuit at 11-16V (more of both is better), but how to go about it? Should I connect a bunch of power-resistors in parallel to the circuit, or is there a better way?
I guess I need a load of 0.4-0.8 Ohms...
What would you suggest?
All advice is greatly appreciated.
/Pax
I need to do some stress-testing of a DC-motor control circuit, but without the motor - Problem is, I'm not sure how to make this the most clever (and cheap) way.
I need to run 30-40A through my circuit at 11-16V (more of both is better), but how to go about it? Should I connect a bunch of power-resistors in parallel to the circuit, or is there a better way?
I guess I need a load of 0.4-0.8 Ohms...
What would you suggest?
All advice is greatly appreciated.
/Pax