Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

DAC0830

bnjsxz

New Member
I need to simulate the operation of the DAC0830 IC in the Proteus software, I can't find any tutorial on YT, I am a new engineering student. Plis
 
Internally this is basically it, Fig. 17 :

1721298621061.png


1721298749235.png


And its double buffered, so create that on your schematic.


Regards, Dana.
 
I think this tutorial will be helpful: https://www.eeeguide.com/dac0830-digital-to-analog-converter/
Here is the datasheet: https://www.jameco.com/Jameco/Products/ProdDS/128186.pdf
You can also use PCF8591 instead:
 
For simulating the DAC0830 IC in Proteus, it's common to encounter limited resources, especially for specific components like DACs. Here’s a step-by-step approach to get started with DAC simulation, which should help even as a beginner.

  1. Install Proteus and Libraries: Ensure you have Proteus installed, and look up any library files needed for DAC0830. Sometimes additional libraries need to be imported manually, which you can find on engineering forums or libraries like GitHub.
  2. Set Up a Basic Circuit: Start with a basic circuit setup in Proteus:
    • Use a microcontroller like an STM32 or Arduino (if available in your library) to send digital signals to the DAC0830.
    • Connect the output of the DAC0830 to an oscilloscope in Proteus, so you can observe the analog output.
  3. Programming the Microcontroller: You’ll need to program the microcontroller to send specific digital values to the DAC. Use simple code to increment and decrement the digital values so that you can observe changes in the analog output on the oscilloscope.
  4. Check Similar Tutorials: While there might not be a tutorial for DAC0830 specifically, DAC simulations with other models often use similar steps, and those can provide some valuable insight. Look up tutorials for other DACs in Proteus, as many concepts transfer over.
For further assistance, you can explore products like the PCF8591P (another DAC/ADC IC) as an alternative or for practice, which is available here. This could give you a more accessible start with DACs in Proteus as you develop your skills.

Best of luck with your simulation and studies!
 

Latest threads

New Articles From Microcontroller Tips

Back
Top