Custom electronics small business

Can anyone refer me to a small custom electronics builder?

I can only find "big league" companies online, but would like to find a smaller possibly hobbiest type to give my requirements a look and price.

Sounds a bit like a dial back engine timing strobe light.

Being that it is on a shaft, and I've seen a simular product that does not have multible inputs to self generate the signal in anticipation, I would imagine retarding it past 360 degrees would then put it "ahead". This is a piggy back like many others, that with the right logic when asked to advance, will allow the original pulse to go through (to prevent a MIL) and then also send a pulse so much in retard, its perceived as advanced to the circuit being piggybacked off of.

Any help on the original question, a small custom electronics business? I know its not to be a time machine and advance a signal waiting to yet be seen, but its a task in other ways that has been done.

You could move (advance) the sensor 20 degrees and then it would be in real time.

Moving the three sensor tabs is not an option, though I see what your saying. I think I will edit my posts to address the real question at hand.

BlackSportD said:

Moving the three sensor tabs is not an option, though I see what your saying. I think I will edit my posts to address the real question at hand.

Click to expand...

You just made all of the replies meaningless and confusing, but maybe it will save you a lot of unwanted future replies.

BlackSportD, I sent a link to this thread to my neighbor, who does exactly what you are looking for.

Awesome, thanks. I think explaining the circuit to circuit gurus off-kilted the direction haha. A lot of problem solvers here, not yellow pages haha.

I wish I had the knowledge level to have a plan of attack circuit wise and could come here to ask questions about the design, but I'm far from that level.

BlackSportD, see the PM I sent you.

Perhaps it has been done, waiting for you.