Could someone tell me what this is?

S

schmokey

New Member

• Feb 16, 2013

• #1

Hi everybody,

sorry to just barge in like this but I'm hoping someone could tell me what **broken link removed**is.

And then I mean specifically the little conductive pads on the resistors are sitting on? I think that this just a piece of acrylic plastic with the components somehow attached (soldered?) and I'm looking for a similar product for a little DIY project. I'd like to use them to attach resistors for some led's. Eventually this should end up being the underside of a back lit (With led's) switch panel.

Any help much appreciated.

thanks,

Schmokey

 

Ian Rogers

User Extraordinaire

Forum Supporter

Most Helpful Member

• Feb 17, 2013

• #2

They look like mosfet relays... The larger pins being the power switch..

By the way... Welcome to the forum...

 

alec_t

Well-Known Member

Most Helpful Member

• Feb 17, 2013

• #3

I mean specifically the little conductive pads on the resistors are sitting on? I think that this just a piece of acrylic plastic with the components somehow attached (soldered?)

Click to expand...

The 'acrylic' looks like a fibreglass board and the pads are part of a printed circuit formed on the board.

 

Ian Rogers

User Extraordinaire

Forum Supporter

Most Helpful Member

• Feb 18, 2013

• #4

No Idea what I read.... Sorry about that Schmokey.... (They do look like mosfet relay's though..)

 

ClydeCrashKop

Well-Known Member

Most Helpful Member

• Feb 18, 2013

• #5

That is prototyping PC BOARD SQ PAD-PER-HOLE
https://www.digikey.com/product-detail/en/8003/V1046-ND/5318

https://www.electro-tech-online.com/custompdfs/2013/02/Vectorbord20Round20pads.pdf

 

S

schmokey

New Member

• Feb 21, 2013

• #6

I guess I phrased the question a bit awkwardly, really what I'm looking for is a small bit of thick PCB as it will need to be glued on it's side to the bottom of the switchpanel.

Thanks for your help!

 

4pyros

Well-Known Member

Most Helpful Member

• Feb 21, 2013

• #7

Can you glue two standerd boards together?

 

S

schmokey

New Member

• Feb 22, 2013

• #8

yeah I think that's what I'll end up doing. I've been looking around for nice thick PCB but can't really find any.

I'm sure I'll be able to work something out, was just hoping I might find a nice ready made and elegant solution.

 

ronv

Well-Known Member

Most Helpful Member

• Feb 22, 2013

• #9

I think your picture is of the carrier for the parts as they come from the factory. The "stuff" above was originally holding the parts down. It is interesting that it looks like solder pads on it. I think it is similar to this except rigid.
https://www.electro-tech-online.com/custompdfs/2013/02/sot23.pdf

 

ClydeCrashKop

Well-Known Member

Most Helpful Member

• Feb 23, 2013

• #10

I like the Human Readable Labels.

 

4pyros

Well-Known Member

Most Helpful Member

• Feb 23, 2013

• #11

ClydeCrashKop said:

I like the Human Readable Labels.

Click to expand...

I was going to say that too. LOL They even have a sample "Human Readable Label" Ha Ha

 

ClydeCrashKop

Well-Known Member

Most Helpful Member

• Feb 23, 2013

• #12

"Press 2 for Human"