N nokia_sa New Member Jan 6, 2012 #1 I want to control a servo motor with PWM (50Hz) using mikroC pro NOTE: the servo motor uses a signal with 20ms or 50Hz PLEASE HELP
I want to control a servo motor with PWM (50Hz) using mikroC pro NOTE: the servo motor uses a signal with 20ms or 50Hz PLEASE HELP
alec_t Well-Known Member Most Helpful Member Jan 6, 2012 #2 Check out other posts about servo control in this forum.
G Gobbledok Active Member Jan 6, 2012 #3 The PWM will be too fast to control a servo, you will have to do it in software. As Alec said, there are a few threads around here on controlling servos.
The PWM will be too fast to control a servo, you will have to do it in software. As Alec said, there are a few threads around here on controlling servos.
P Pommie Well-Known Member Most Helpful Member Jan 6, 2012 #5 Check out https://www.electro-tech-online.com/threads/junebug-servo-c18-code.36127/. it's for a 18 series chip but the principle is the same for all pics. Mike.
Check out https://www.electro-tech-online.com/threads/junebug-servo-c18-code.36127/. it's for a 18 series chip but the principle is the same for all pics. Mike.
X xainnasir New Member Jan 7, 2012 #6 servo motor is not much difficult to operate .... check this link ..... it will help completely .... .... Moreover if you want a ready made project then send me a message .... u will get it within 10 days .... Last edited by a moderator: Jan 7, 2012
servo motor is not much difficult to operate .... check this link ..... it will help completely .... .... Moreover if you want a ready made project then send me a message .... u will get it within 10 days ....