Ok, so iv been looking around on the net for a few days looking for ways to make a half decent wind turbine.
Iv so far found that if i use 9 coils and 12 magnets i can produce a 3 phase output, if i wind my coils to have 70 turns on each coil, i can easily generate 24v.
The magnets described are N35 grade.
Overall this setup is supposed to easily deliver 700w - 1000w in 10 - 15mph winds
Ok, so thats the basic setup.
Here come the questions,
How would i go about increasing the current output, the voltage ideally should remain at 24v
Also how would i go about making them produce better currents at slower speeds?
At the moment this is all on paper so if the setup needed changing then i can do that.
Iv so far found that if i use 9 coils and 12 magnets i can produce a 3 phase output, if i wind my coils to have 70 turns on each coil, i can easily generate 24v.
The magnets described are N35 grade.
Overall this setup is supposed to easily deliver 700w - 1000w in 10 - 15mph winds
Ok, so thats the basic setup.
Here come the questions,
How would i go about increasing the current output, the voltage ideally should remain at 24v
Also how would i go about making them produce better currents at slower speeds?
At the moment this is all on paper so if the setup needed changing then i can do that.