Hi.
2 months ago, I had a problem with a for loop which caused a device to enter into an infinite loop.
After fixing it, I didnt encounter any cases where the code stopped running, until now.
I burned the code into 4 units, however there is one unit which its code stopped running.
I think it might have something to do with HW rather than SW, since the 3 other units are running well.
However, I'm not 100% sure its an HW problem.
Do you know of any HW problems that could cause a unit's code to stop running?
Any other tip would help.
Thanks.
2 months ago, I had a problem with a for loop which caused a device to enter into an infinite loop.
After fixing it, I didnt encounter any cases where the code stopped running, until now.
I burned the code into 4 units, however there is one unit which its code stopped running.
I think it might have something to do with HW rather than SW, since the 3 other units are running well.
However, I'm not 100% sure its an HW problem.
Do you know of any HW problems that could cause a unit's code to stop running?
Any other tip would help.
Thanks.
Last edited: