E EngIntoHW Member Nov 29, 2011 #1 Hi, I need to draw Y as function of A: I performed the following simulation. Is it correct? Thanks. Attachments buffer.jpg 13.6 KB · Views: 576 Non Interting Buffer.jpg 289.3 KB · Views: 637 Last edited: Nov 29, 2011
E EngIntoHW Member Nov 30, 2011 #3 Thanks Brownout! Did I connected the PMOS and NMOS correctly? I just want to be sure that I got the source and drain connected properly.
Thanks Brownout! Did I connected the PMOS and NMOS correctly? I just want to be sure that I got the source and drain connected properly.
M MrAl Well-Known Member Most Helpful Member Nov 30, 2011 #4 Hi, Yes the simulation looks ok but notice the output only goes down as low as about 4v. That's because without a negative input you cant turn the P channel device on hard enough.
Hi, Yes the simulation looks ok but notice the output only goes down as low as about 4v. That's because without a negative input you cant turn the P channel device on hard enough.
B BrownOut Banned Nov 30, 2011 #6 Notice also the severe crossover distortion, caused by the threshold voltage.