darklordchris
New Member
i have recently received a small fender amplifier that needs to have a new input jack soldered on to the pcb. however the board is damaged. where the input jack should go in the circuit path dosen't have any lands. it looks like someone who wasen't very good with a soldering iron and melted them out while trying to remove the old input jack.
i've looked over several ways to hook up the jack, but i'm not really sure what the best method would be. i don't know if it would be a better idea to solider in new lands or connect the jack to the circuit with wire or some other method.
i've looked over several ways to hook up the jack, but i'm not really sure what the best method would be. i don't know if it would be a better idea to solider in new lands or connect the jack to the circuit with wire or some other method.