Capacitive effect on tracks

Hello good time
I designed a board that has a Micro 328 , Has 3 touch channels, and works fine, but when i put nrf on board, two of the channels don't work, and it crashes.
But when I remove the nrf from the board and reset the micro, the circuit breaks again (I opened the nrf on the board and wired it to the board, but it didn't work again)
What do you think it could be? I was confused whether it could be a capacitive effect or something else.

whats a nrf?

Hi

Check all supply voltages and see if at the right level when nrf connected.

eT

yes,all supply voltages are at the right level but not working.